GSC bus

This article has multiple issues. Please help improve it or discuss these issues on the talk page. (Learn how and when to remove these messages) The topic of this article may not meet Wikipedia's general notability guideline. Please help to demonstrate the notability of the topic by citing reliable secondary sources that are independent of the topic and provide significant coverage of it beyond a mere trivial mention. If notability cannot be shown, the article is likely to be merged, redirected, or deleted. Find sources: "GSC bus" – news · newspapers · books · scholar · JSTOR (November 2022) (Learn how and when to remove this message) This article needs additional citations for verification. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "GSC bus" – news · newspapers · books · scholar · JSTOR (November 2022) (Learn how and when to remove this message) This article relies largely or entirely on a single source. Relevant discussion may be found on the talk page. Please help improve this article by introducing citations to additional sources. Find sources: "GSC bus" – news · newspapers · books · scholar · JSTOR (November 2022) (Learn how and when to remove this message)

GSC is a bus used in many of the HP 9000 workstations and servers. The acronym has various explanations, including Gecko System Connect (Gecko being the codename of the 712 workstation), Gonzo System Connect and General System Connect.

GSC was a general 32-bit I/O bus, similar to NuBus or Sun's SBus, although it was also used as a processor bus with the PA-7100LC and PA-7300LC processors. Several variations were produced over time, the later ones running at 40 MHz:

GSC-1X

The original GSC bus implemented on PA-7100LC and used in the Gecko (712), Mirage (715) and Electra computers. Peak Bandwidth 142 MB/s w/DMA, 106 MB/s with PIO writes.

GSC+, a.k.a. "Extended GSC" or "EGSC"

Enhancements added for KittyHawk/SkyHawk (U2 chip) that allow for pending transactions. GSC+ enhancements are orthogonal to the GSC-1.5X and GSC-2X enhancements.

GSC-1.5X

GSC-1X with an additional variable length write transaction.

GSC-2X

GSC-1.5X with a protocol enhancement to allow data to be sent at double the GCLK rate, with a peak bandwidth of 256 MB/s.

HSC

High Speed Connect.

Four types of GSC cards were produced: the GIO cards fit into the larger of the two IO card sockets in the 712 workstation. Several were produced, including a second RS-232 serial port, a serial/10BaseT combo, a second graphics card and a Token Ring card.

The 715/Mirage, 725, 735, 755, B-, C-, and J-class workstations, and the D- and R-class servers, used the so-called "EISA form factor". Many different types of card were produced, including Gigabit Ethernet, single and dual 100 Mbit Ethernet, Ultra-2 SCSI, ATM and graphics.

The K- and T-class servers both used the "3x5" form factor, although the different brackets prevent the cards being interchangeable. Fibre channel and Gigabit Ethernet cards both exist.